the m102 series master clock oscillators range in frequency from 200mhz to 1ghz. these highly-stable, low-noise devices have on-board crystal references and provide complementry clock outputs with less than 3ps (rms) typical jitter. the m102 series was developed specifically to meet tough performance requirements found in todays high-end risc-based computers, telecom transmission, base station, ate, and datacom applications. packaged in small, 24-pin double-wide metal dip packages, the m102 series master clock oscillators are available with either ecl or pecl output formats. these models operate from a single supply (+5v for pecl or -5v for ecl). standard k models are specified for 0 c to +70 c operation. extended temperature range l models are available for -25 c to +85 c operation. n 200mhz to 1ghz output frequency n low 3ps typical phase jitter n 10, 25, and 40ppm stability options n ecl/pecl differential outputs n single supply operation n 24-pin dip package n 0 c to +70 c and -25 c to +85 c operation features: features: master clock oscillators for additional information regarding custom microelectronic products and services, please contact micro networks at: m102 series 324 clark st., worcester, ma 01606 tel. (508) 852-5400 ? fax (508) 853-8296 e-mail C sales@mnc.com web site C http://www.mnc.com
ordering information part number m102e0890.0000ak select device output format specify e for ecl output format or p for pecl output format select device output frequency xxxx.xxxxmhz stability over temperature range: a = 10ppm c = 25ppm d = 40ppm add k suffix for 0 c to +70 c operation add l suffix to c for d models for -25 c to +85 c operation absolute maximum ratings operating temperature range -25 c to +85 c specified temperature range m102x-xxxx.xxxx x k 0 c to +70 c m102x-xxxx.xxxx x l -25 c to +85 c storage temperature range -55 c to +125 c supply m102e -7.0 to 0 volts supply m102p 0 to + 7.0 volts specifications @ t a =+25 c, power supply = nominal, unless otherwise indicated specifications m102 series master clock oscillators 324 clark st., worcester, ma 01606 tel. (508) 852-5400 ? fax (508) 853-8296 e-mail C sales@mnc.com web site C http://www.mnc.com notes: 1. symmetry is measured at v bb = -1.35v for m101e models and v bb = v cc -1.35v for m101p models. 2. the output is measured with a 50 ohm termination resistor connected to -2v for m102e and +3v for m102p. output frequency range frequency stability over temperature range: m102x-xxxx.xxxx a x m102x-xxxx.xxxx c x m102x-xxxx.xxxx d x symmetry (note 1) rise/fall time: (20% to 80%) output configuration: m102e m102p output voltage: m102p m102e output drive output phase jitter power supply voltage: m102e m102p power supply current: m102e m102p min. typ. max. units 200 1000 mhz 10 ppm 25 ppm 40 ppm 45/55 50/50 55/45 % 100 psec differential ecl differential pecl pecl compatible ecl compatible 50 ma 3 5 psec (rms) -4.5 -5.00 -5.5 volts +4.5 +5.00 +5.5 volts -95 ma +95 ma
pin designations package outline m102p model 1. ground 24. ground 2. ground 23. ground 3. ground 22. ground 4. ground 21. +5 volts 5. +5 volts 20. ground 6. ground 19. test point 7. +5 volts 18. ground 8. ground 17. +5 volts 9. +5 volts 16. ground 10. f out q 15. test point 11. f out q 14. ground 12. +5 volts 13. +5 volts m102e model 1. ground 24. ground 2. ground 23. ground 3. ground 22. -5 volts 4. -5 volts 21. ground 5. ground 20. -5 volts 6. -5 volts 19. test point 7. ground 18. -5 volts 8. -5 volts 17. ground 9. ground 16. -5 volts 10. f out q 15. test point 11. f out q 14. -5 volts 12. ground 13. ground m102 series master clock oscillators 324 clark st., worcester, ma 01606 tel. (508) 852-5400 ? fax (508) 853-8296 e-mail C sales@mnc.com web site C http://www.mnc.com 13 24 12 1 top view 1.273 (32.334) .773 (19.634) .260 (6.604) .600 (15.240) .085 (2.159) .261 (6.629) .085 (2.159) 1.100 (27.940) .100 (2.540) 11 pl .020 (.508)
4.7uf 25v .01 .01 .01 .01 .01 .01 .01 .01 .01 m102e series 1 2 3 4 5 6 7 8 9 10 11 12 24 23 22 21 20 19 18 17 16 15 14 13 -5v -2v 50 -2v f out 50 f out 4.7uf 25v .01 .01 .01 .01 .01 .01 .01 .01 m102p series 1 2 3 4 5 6 7 8 9 10 11 12 24 23 22 21 20 19 18 17 16 15 14 13 +5v +3v 50 +3v f out 50 f out + + application circuits 324 clark st., worcester, ma 01606 tel. (508) 852-5400 ? fax (508) 853-8296 e-mail C sales@mnc.com web site C http://www.mnc.com m102 series master clock oscillators
|
